Final Adjustments of the Command Console

FINAL ADJUSTMENTS OF THE COMMAND CONSOLE

Loosen the screws on each of the front Z-Lock mounts.

Slide the Console partially out.

Use a flathead screw driver to slightly move the Z-Locks out away from the Console.

Tighten all the screws on the front Z-Lock mounts.

Slide the Console in and out to see if it moves smoothly.

Go back to the rear of the rack and fully tighten the slide extension rail screw ((U) see page 30 - Install hardware ).screws.

Note: A wrench may be necessary to hold the nut on the other side.

Doc# 27-0001UM Issued 7/99 Rev. 1.2