•Screw the hose back to the machine and make sure the connection is tight.
•Turn on the water tap.
Frost precaution
If the machine is exposed to temperatures below 0°C, certain precautions should be taken.
•Turn off the water tap.
•Unscrew the inlet hose.
•Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out.
•Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again.
•When you intend to start the machine up again, make sure that the room temperature is above 0°C.
Emergency emptying out
If the water is not discharged, proceed as follows to empty out the machine:
•pull out the plug from the power socket;
•close the water tap;
•if necessary, wait until the water has cooled down;
•open the pump door;
•place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Empty the bowl. Repeat the procedure until water stops flowing out;
•clean the pump if necessary as previously described;
•replace the emergency emptying hose in its seat after having plugged it;
•screw the pump cover again and close the door.
Important! Every time you drain the water through the emergency emptying hose you must pour 2 litres of water into the main wash compartment of the detergent drawer and then run the drain programme. This will activate the ECO Valve device avoiding that part of the detergent remains unused at next washing.
Installation
Unpacking
All transit bolts and packing must be removed before us- ing the appliance.
You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.
After removing all the | Remove the power supply |
packaging, carefully lay | cable and the hoses from |
machine on it's back to re- | the hose holders on the |
move the polystyrene base | rear of the appliance. |
from the bottom. |
|
Unscrew the three bolts. | Slide out the relevant plas- |
| tic spacers. |
18
