Residual Heat Function
When a Cooking Duration time is set, the heating elements of the oven will automatically go off a few minutes before the end of the programmed time, and the oven will use the residual heat to finish your dishes without energy consumption. All current settings will be displayed until the Cooking Duration time is over.
This function will not operate when the Cooking Duration time is less than 15 minutes.
"Demo" mode
This mode is intended to be used in the shops to dem- onstrate the oven functionality without any power con- sumption except the oven lamp. To activate this func- tion the appliance should be off.
1.Press control and “ “ at the same time for approximately 2 seconds (Fig. 20). The Electronic Control beeps once.
2.When you touch control to switch on the oven, the message "DEMO" appears on the upper section of the display (Fig. 21). You can then select any cooking function, but the oven will not heat up. The
thermometer symbol will come on |
| , but it will not |
| ||
flash nor rise. |
|
|
To disable the demo mode:
Press control to switch off the oven, then press control and ““ at the same time for approximately 2 seconds. The Electronic Control beeps once and the oven is ready to operate.
"Beep" Mode
You can choose to make The Electronic Control beep each time that a control is touched.
To enable this function, the oven must be off.
1.Press controls and "" at the same time for about 3 seconds. The Electronic Control beeps once (Fig. 22).
To disable the "Beep" Function:
1.If the oven is on, touch control to switch it off.
2.Press controls and "" at the same time for about 3 seconds. The Electronic Control beeps once
Error code
The Oven Electronic Control does a continuous diagnostic check of the system. If some parameters are not correct, the control unit will stop the activated functions and the corresponding error code will be displayed.
Fig. 20
Fig. 21
Fig. 22
12