Zanussi ZBS 1063 manual Residual Heat Function, Demo mode, Beep Mode, Error code, Fig. Fig. Fig

Models: ZBS 1063

1 28
Download 28 pages 54.03 Kb
Page 12
Image 12
Residual Heat Function

Residual Heat Function

When a Cooking Duration time is set, the heating elements of the oven will automatically go off a few minutes before the end of the programmed time, and the oven will use the residual heat to finish your dishes without energy consumption. All current settings will be displayed until the Cooking Duration time is over.

This function will not operate when the Cooking Duration time is less than 15 minutes.

"Demo" mode

This mode is intended to be used in the shops to dem- onstrate the oven functionality without any power con- sumption except the oven lamp. To activate this func- tion the appliance should be off.

1.Press button "Demo" mode and “ To disable the demo mode:“ at the same time for approximately 2 seconds (Fig. 20). The Electronic Control beeps once.

2.When you press button "Beep" Mode to switch on the oven, the message "DEMO" appears on the upper section of the display (Fig. 21). You can then select any cooking function, but the oven will not heat up. The

thermometer symbol will come on

 

, but it will not

 

flash nor rise.

 

 

To disable the demo mode:

Press button To disable the "Beep" Function: to switch off the oven, then press button

Error code and “ Manual background“ at the same time for approximately 2 seconds. The Electronic Control beeps once and the oven is ready to operate.

"Beep" Mode

You can choose to make The Electronic Control beep each time that a button is pressed.

To enable this function, the oven must be off.

1.Press buttons Manual background and "Manual background" at the same time for about 3 seconds. The Electronic Control beeps once (Fig. 22).

To disable the "Beep" Function:

1.If the oven is on, press button Manual background to switch it off.

2.Press buttons Manual background and "Manual background" at the same time for about 3 seconds. The Electronic Control beeps once

Error code

The Oven Electronic Control does a continuous diagnostic check of the system. If some parameters are not correct, the control unit will stop the activated functions and the corresponding error code will be displayed.

For further details, refer to chapter “Something not working”.

Fig. 20

Fig. 21

Fig. 22

12

Page 12
Image 12
Zanussi ZBS 1063 manual Residual Heat Function, Demo mode, Beep Mode, Error code, To disable the demo mode, Fig. Fig. Fig