Dimension

mm

F

less then 400

Levelling

Use small feet on the bottom of appliance to set same lev- el of cooker top surface with other surfaces

The stability chain

Caution! You must install the stability chain. If you do not install it the appliance can tilt.

Before you install stability chain, adjust the appliance to the correct height.

Measure down 180 mm from the appliance top surface, then measure right 30 mm (See picture). Mark the posi- tion of the wall and this gives anchor point for the stability chain.

180 mm

30mm

Warning! These instructions are only valid in the countries whose symbols appear on this booklet's

cover.

 

 

 

 

 

Gas Category

 

I2H

Gas Supply

 

G20 - 20 mbar

 

 

 

Gas burners

BURNER

Auxiliary burner

Semi-rapid burner

Rapid burner

Grill

Top Oven

Main Oven

NORMAL POWER

kW

1,0

1,9

3,0

2,7

1,9

1,9

NATURAL GAS

inj. 100/mm

Btu/h

70

3412

96

6483

119

10236

120

9212

99

6483

99

6483

Gas Connection

Use a flexible pipe in compliance with the regulation in force. Be careful they do not come in touch with mobile parts or they are not squeezed.

Warning! Only a qualified and competent person must do the gas installation.

Warning! Before gas connection disconnect the mains plug from the mains socket or switch off the

fuse in the fuse box. Close the primary valve of the gas supply.

Supply piping should not be less than R3/8. Con- nection is made to the Rc ½ (1/2 “ B.S.P.) female threaded. Entry pipe located just below the hob level on

the rear left hand side of the appliance.

The gas supply ramp is on the rear side of the appliance.

Warning! Only liquid sealants to be used when inlet gas pipe is fitted i.e.: do not use P.T.F.E. sealant

tape.

When installation is complete. Carry out a gas tightness test and make sure that the seal of each pipe fitting is correct.

20

Page 20
Image 20
Zanussi ZCG551 manual Gas burners, Levelling, Stability chain, Inj /mm