Zanussi ZCV662 What to do if…, Oven lamp, Before you change the oven lamp, Problem, Remedy

Models: ZCV662

1 24
Download 24 pages 4.92 Kb
Page 17
Image 17
Oven lamp

To replace the glass panels obey the procedure in opposite sequence. Before you lower the trim attach

the A trim part to the door. Refer to picture.

Oven lamp

Warning! There is a danger of electrical shock!

Before you change the oven lamp:

Switch off the oven.

Remove the fuses in the fuse box or switch off the cir- cuit breaker.

Put a cloth on the bottom of the oven for protection of the oven light and glass cover.

Replacing the oven lamp

1.You can find the lamp glass cover at the back of the cavity.

Turn the lamp glass cover counterclockwise to re- move it.

2.Clean the glass cover.

3.Replace the oven lamp with applicable 300°C heat- resistant oven lamp.

Important! Use the same oven lamp type.

4.Install the glass cover.

What to do if…

Warning! Refer to "Safety information" chapter.

Problem

The hob does not operate

The oven does not heat up

The oven does not heat up

The oven does not heat up

The oven does not heat up

The oven lamp does not operate

Steam and condensation settle on the food and in the oven cavity

The display shows “12.00”

The residual heat indicator does not come on

Possible cause

The heat setting is not set

The oven is not switched on

The clock is not set

The necessary settings are not set

The fuse in the fuse box is released

The oven lamp is defective

You left the dish in the oven for too long

A power cut

The cooking zone is not hot because it operated only for a short time.

Remedy

Set the heat setting Switch on the oven Set the clock Control the settings

Control the fuse. If the fuse is re- leased more than one time, refer to a qualified electrician.

Replace the oven lamp

Do not leave the dishes in the oven for longer than 15-20 minutes after the cooking process ends

Reset the clock

If the cooking zone must be hot, speak to the Service Centre.

If you cannot find a solution to the problem yourself, con- tact your dealer or the service centre.

We recommend that you write the data here: Model (MOD.)

Product number (PNC) Serial number (S.N.)

The necessary data for the service centre is on the rating plate. The rating plate is on the front frame of the oven cavity.

.........................................

.........................................

.........................................

17

Page 17
Image 17
Zanussi ZCV662 user manual What to do if…, Oven lamp, Before you change the oven lamp, Problem, Possible cause, Remedy