Something not working
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be
Fault code and malfunction
appears in the digital display. The dishwasher does not fill with water.
appears in the digital display.
The dishwasher will not drain.
appears in the digital display.
The programme does not start.
solved with the help of the indications described in the chart, without calling out an engineer. Switch off the dishwasher and carry out the fol- lowing suggested corrective actions.
Possible cause and solution
•The water tap is blocked or furred with limescale. Clean the water tap.
•The water tap is turned off. Turn the water tap on.
•The filter (where present) in the threaded hose fitting at the water inlet valve is blocked.
Clean the filter in the threaded hose.
•The water inlet hose has not been correctly laid or it is bent or squashed.
Check the water drain hose connection.
•The sink spigot is blocked. Clean out the sink spigot.
•The water drain hose has not been correctly laid or it is bent or squashed.
Check the water drain hose connection.
•Close the water tap and contact your local Service Force Centre.
•The dishwasher’s door has not been properly closed. Close the door.
•The main plug is not plugged in. Insert the main plug.
•The fuse has blown out in the household fuse box. Replace the fuse.
•Delay start has been set.
If dishes are to be washed immediately, cancel the delay start.
Once these checks have been carried out; switch on the dishwasher. The programme will continue from the point at which it was inter- rupted.
If the malfunction or fault code reappears con- tact the Service Force Centre.
For other fault codes not described in the above chart, please contact your Service Force Cen- tre.
Contact your local Service Force Centre, quot- ing the model (Mod.), product number (PNC) and serial number (S.N.). This information can be found on the rating plate located on the side
21
