INSTALLATION INSTRUCTIONS
-Remove the plug from the upper part of the ducting fan unit, as it is not possible to insert the flange F with the plug in place.
-Fit the flange F Ø120 or 150 mm,replace the plug.
· Air outlet directed to the right or left hand side.
-Remove the four screws fastening the plastic frame, as shown in figure .
-Fit the ducting spigot R and replace the four screws removed as above.
Fixing the chimney
a)Loosen the screws M fixing the two parts of the chimney and pull the inner section I almost all the way out. Remove the protective film P .
b)Rest the lower section of the chimney in its housing on the top of the hood canopy. Lower the ducting fan unit until it reaches the wall bracket S and fix it using the screw H provided.Fit the cover D
| (provided) on the wall bracket S. |
|
c) | Fix the chimney to the hood canopy C using the |
|
| four screws provided. |
|
d) | Insert the transparent seal Q (provided),so as to |
|
| eliminate any play between the two parts of the | _16 |
| chimney . Lock the screws M. | S07 |
|
| |
|
| |
e) Remove the support rod B . |
| |
S
S | H |
R
A08_21
| S07 19 |
|
D |
| I |
|
| P |
| A08_22 | M |
|
| A08_20 |
E | E |
|
E | Q | Q |
| ||
| E |
|
A08_23 | A08_24 |
17
