Troubleshooting
Caution! Before troubleshooting, disconnect the power supply.
Only a qualified electrician or competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem | Possible cause |
The appliance is noisy. | The appliance is not installed properly. |
|
|
The appliance does not operate. | The plug is not connected to the mains |
| socket correctly. |
| The appliance has no power. There is |
| no voltage in the mains socket. |
|
|
The light device does not work. | The light device is in |
| The unit is defective. |
The compressor operates contin- | The temperature is not set correctly. |
ually. |
|
| The door is not closed correctly. |
| The door has been opened too fre- |
| quently. |
| The food temperature is too high. |
|
|
| The room temperature is too high. |
Water flows on the rear plate of | During the automatic defrosting proc- |
the refrigerator. | ess, frost defrosts on the rear plate. |
Water flows into the refrigerator. | The water outlet is clogged. |
| Products prevent that water flows into |
| the water collector. |
Water flows on the ground. | The melting water outlet does not flow |
| in the evaporative tray above the com- |
| pressor. |
The temperature in the appliance | The temperature regulator is not set |
is too low/high. | correctly. |
|
|
Solution
Check if the appliance stands stable (all the feet should be on the floor).
Connect the plug to the mains socket correctly.
Connect a different electrical appliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the control unit".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than necessary.
Let the food temperature decrease to room temperature before storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch the rear plate.
Attach the melting water outlet to the evaporative tray.
Set a higher/lower temperature.
If your appliance is still not working properly after making the above checks, contact the After Sales Centre. You can find the list at the end of this manual.
Replacing the control unit
The appliance is equipped with a longlife LED interior light.
www.zanussi.com
Only service is allowed to replace the control unit. Contact your Service Center.
Closing the door
1.Clean the door gaskets.
2.If necessary, replace the defective door gaskets. Contact the After Sales Service.
9
