Zanussi ZSF2450 manual Setting and starting a washing programme, Use of detergent tablets

Models: ZSF2450

1 20
Download 20 pages 38.53 Kb
Page 10
Image 10
Use of detergent tablets

A

56

Use of detergent tablets

Put the detergent tablet in the detergent dis- penser (A).

Detergent tablets contain:

detergent

rinse aid

other cleaning agents.

Do these steps to use detergent tablets:

1.Make sure that the detergent tablets are ap- plicable for your water hardness. Refer to the instructions from the manufacturer.

2.Set the lowest levels of water hardness and rinse aid dosage.

It is not necessary to fill the salt container and the rinse aid dispenser.

Do these steps when the drying results are not satisfactory:

1.Fill the rinse aid dispenser with rinse aid.

2.Set the rinse aid dosage to position 2.

Do these steps to use the detergent powder again:

1.Fill the salt container and the rinse aid dis- penser.

2.Set the water softener to the highest level.

3.Do a washing programme without dishes.

4.Adjust the water softener. Refer to the chap- ter 'Setting the water softener'.

5.Adjust the rinse aid dosage.

Different brands of detergent dissolve in different times. Some detergent tablets do

not have the best cleaning results during short washing programmes. Use long washing pro- grammes when you use detergent tablets to fully remove the detergent.

Setting and starting a washing programme

Do these steps when the drying results are not satisfactory: Set the washing programme with the door ajar. The washing programme only starts af- ter you close the door. Until then it is possible to

modify the settings.

Do these steps to set and start a washing pro- gramme:

1.Switch on the appliance.

2.Make sure that the appliance is in setting mode.

3.Press one of the programme buttons. Refer to the chapter 'Washing programmes'.

The programme indicator light comes on.

All other programme indicator lights go off.

The digital display shows in flashing the programme duration.

The phase indicator light for the washing programme starts to flash.

4.Close the door.

10

The washing programme starts automati- cally.

The phase indicator light for the washing programme is on.

When the washing programme operates, you cannot change the programme. Cancel

the washing programme.

Warning! Only interrupt or cancel a washing programme if necessary.

Caution! Open the door carefully. Hot steam can come free.

Cancelling a washing programme

1.Press and hold function buttons B and C until all the programme lights come on.

2.Release function buttons B and C to cancel

the washing programme.

At this time you can do these steps:

1.Switch off the appliance.

Page 10
Image 10
Zanussi ZSF2450 manual Setting and starting a washing programme, Use of detergent tablets, Cancelling a washing programme