What to do if…
The appliance does not start or stops during op- eration.
If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to
the problem yourself, contact your dealer or the Service Force Centre.
Fault code and malfunction
• digital display shows 
The dishwasher does not fill with water
•digital display shows 
The dishwasher will not drain
•the drain pump operates contin- uously
•all indicators lights on the control panel go off
The
The programme does not start
Possible cause and solution
•The water tap is blocked or furred with limescale. Clean the water tap.
•The water tap is closed. Open the water tap.
•The filter in the water inlet hose is blocked. Clean the filter.
•The connection of the water inlet hose is not correct. The hose can be kinked or squashed.
Make sure that the connection is correct.
•There is a blockage in the sink spigot. Clean the sink spigot.
•The connection of the water drain hose is not correct. The hose can be kinked or squashed.
Make sure that the connection is correct.
•Close the water tap and contact your local Service Force Centre.
•The appliance door is not closed. Close the door.
•Mains plug is not connected in. Put in the mains.
•The fuse has blown out in the household fuse box. Replace the fuse.
•Delay start is set.
Cancel the delay start to start the programme immediately.
After the check, switch on the appliance. The programme continues from the point of inter- ruption. If the malfunction shows again, contact your Service Force Centre.
These data are necessary to help you quickly and correctly:
• Model (Mod.)
•Product number (PNC)
•Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........
13
