Zanussi ZSF2450 manual Electrical connection, Drain hose

Models: ZSF2450

1 20
Download 20 pages 38.53 Kb
Page 16
Image 16
Drain hose

If the water inlet hose is too short, replace the water inlet hose with an applicable, longer high- pressure hose. Do not connect an extension hose. To suit the installation, it is possible to turn the end of the hose that is connected to the dish- washer. Do these steps :

1. Loosen the retain- ing nut.

2. Turn the hose.

3. Tighten the retain- ing nut.

Connect the inlet hose to a water tap with an external thread of 3/4”.

Warning! Make sure that the retaining nut and all other connections are tight before

you move the dishwasher into position.

Warning! Always use a new water inlet hose. Do not use connection hoses from an old

appliance.

Drain hose

The appliance has water safety system to prevent water damage. If there is a malfunc-

tion, the drain pump automatically starts to drain the remaining water out of the dishwasher.

Warning! Only if the dishwasher is

connected to the mains socket, the water safety system operates when the dishwasher is off.

Two procedures are possible to install the water drain hose :

Electrical connectionManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background 1

Manual background2

max. 75cm

1.Attach the plastic curve supplied at the end of the hose.

Put the water drain hose in the sink.

2.Connect the water drain hose to the water drain system.

The hose must be less than 75 cm above the bottom of the dishwasher to prevent in- correct operation of appliance.

If you connect the wa- ter drain hose to a trap spigot under the sink, remove the plastic membrane (A). If you do not remove the membrane, remaining food can cause a blockage in the drain hose spigot

Electrical connection

Warning! The manufacturer is not responsible if you do not follow these safety

precautions.

Ground the appliance according to safety precautions.

Make sure that the rated voltage and type of power on the rating plate agree with the voltage and the power of the local power supply. Always use a correctly installed shockproof socket.

Do not use multi-way plugs, connectors and extension cables. There is a risk of fire.

Do not replace the mains cable yourself. Contact the Service Force Centre.

Make sure that the mains plug is accessible after installation.

Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.

16

Page 16
Image 16
Zanussi ZSF2450 manual Electrical connection, Drain hose