Appendix B
PIN | SIGNAL | SIGNAL |
| |
# | NAME | TYPE | FUNCTIONAL DESCRIPTION | |
|
|
|
| |
5 | PAUSE | Input | To toggle the current PAUSE state, this input must be | |
|
|
| asserted LOW for 200 milliseconds, or until the SERVICE | |
|
|
| REQUIRED output (pin 10) changes state. | |
6 | REPRINT | Input | If the REPRINT feature is enabled – this input must be | |
|
|
| asserted LOW to cause the printer to reprint the last label. | |
|
|
| (See the Configuration and Calibration section.) | |
|
|
| If the REPRINT feature is disabled – this Input is ignored. | |
7 | +28V | Power | Interface Power Supply – supplies power to external | |
| (Fused at |
| sensors as required. | |
|
|
| ||
| 1.5A) |
|
| |
8 | POWER | Ground | Interface Power Ground. | |
| GROUND |
|
| |
| (+28V Return) |
|
| |
9 | RIBBON | Output | If the RIBBON LOW feature is enabled, and the amount of | |
| LOW |
| ribbon remaining on the supply spool is below a specific | |
|
|
| threshold level – this output will be asserted HIGH. | |
|
|
| If the RIBBON LOW feature is disabled – this output lead is | |
|
|
| disabled. (See the Configuration and Calibration section.) | |
10 | SERVICE | Output | While either the media cover is open, the printhead is open, the | |
| REQUIRED |
| ribbon is out, the media is out, the printer is paused, or an | |
|
| operational fault has occurred, this output will be asserted LOW.. | ||
|
|
| ||
|
|
| If the applicator RESYNCH mode is set to ERROR mode, | |
|
|
| this signal will also assert LOW for a RESYNCH error. | |
11 | END PRINT | Output | MODE 0: The Applicator Port is OFF. | |
MODE 1: Asserted LOW only while the printer is moving | ||||
|
|
| ||
|
|
| the label forward; otherwise deasserted HIGH | |
|
|
| MODE 2: Asserted HIGH only while the printer is moving | |
|
|
| the label forward; otherwise deasserted LOW. | |
|
|
| MODE 3: (Default) Asserted LOW for 20 milliseconds when | |
|
|
| a label has been completed and positioned. Not asserted | |
|
|
| during continuous printing. | |
|
|
| MODE 4: Asserted HIGH for 20 milliseconds when a label | |
|
|
| has been completed and positioned. Not asserted during | |
|
|
| continuous printing. | |
12 | MEDIA OUT | Output | Asserted LOW while there is no media in the printer. | |
13 | RIBBON OUT | Output | Asserted LOW while there is no ribbon in the printer. | |
14 | DATA | Output | Asserted LOW when sufficient data has been received to | |
| READY |
| begin printing the next label. | |
|
|
| ||
|
|
| ||
|
|
| label, due to either a PAUSE condition or the absence of a | |
|
|
| label format. | |
15 | SPARE | Output | To Be Determined |
Table 4.
| 61 |