Serial Communications

Serial communications between the printer and the host computer can be set by the Y command.

Y Command

Use the serial port setup (Y) command to change the communications settings on the printer.

1.With the host computer set at the same communications settings as the printer, send the Y command to change the printer to the desired settings.

2.Change the host computer settings to match the new printer settings. Refer to the programming guide for more information about this command.

Default the Serial Parameters

The default communications parameters on the printer are 9600 baud, no parity, 8 data bits, 1 stop bit. Many utilities, downloaders and programs use these settings.

16

980483-001A

Page 24
Image 24
Zebra Technologies LP 2844 manual Serial Communications, Command