Using the Cutter Option | Zebra Technologies LP 2844 instruction

Using the Cutter Option

Printers that have a bezel with a motorized blade can dispense one or more forms that are then automatically cut from the media supply. This option cuts through continuous paper from rolls and liner between labels. Keep the cutter dry. Never use any solutions or solvents to clean the blade.

Use the f command to set the cut position and the C command to cut immediately outside a form.

If the blade cuts through labels, adhesive can jam the cutter.

1. Turn OFF (O) printer power and unplug the power and interface cables before clearing the cutter.

2. After removing debris, plug in the power and interface cables, turn on the printer, then test for normal operation.

980483-001A

23

Image 31

Zebra Technologies LP 2844 manual Using the Cutter Option

Contents

Zebra LP 2844 TM 980483-001A Proprietary Statement Shock Hazard Contents Operation & Options 980483-001A Vii 980483-001A Hello Introduction Whats in the Box? Opening the printer Inspecting the Printer Inspecting the Printer Closing the printer Reporting Damage Related Documentation Modes of Printing Getting Started Attaching Power Supply Placing the Roll in the Media Compartment Loading Roll Media Adjusting the Guides Status Light Power SwitchOperator Controls Feed Button Media Length Sensing Interface Cable Requirements Hooking Up the Printer and Computer Serial Interface Requirements USB Interface RequirementsParallel Interface Requirements Ethernet Interface Requirements Internal ZebraNet PrintServer II Communications Communicating with the PrinterUniversal Serial Bus USB Communications Parallel Communications Serial Communications Command Adjusting the Print Quality Adjusting the Print Width 980483-001A Thermal Printing Operation & Options Replacing Supplies Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980483-001A Cleaning Maintenance Print Head Considerations Cleaning Card ConsiderationsMedia Path Considerations Platen Considerations Lubrication Replacing the Platen AssemblyRemoval Replacing the Print Head Removal Direct-Thermal LP Model Assembly 980483-001A What the Status Light is Telling You Troubleshooting Printer Operation Media Handling Printed image does not look right Print Quality ProblemsPrint head is under temperature No print on the label Label format was sent to, but not recognized by, the printer Manual Calibration Communications Diagnostics Resetting the Factory Default Values Printer Condition Feed Button Action Feed Button Modes Appendix Universal Serial Bus USB ConnectorInterfaces Host Parallel Interface ZebraNet PrintServer II Internal Ethernet PrintServer Looking into the Printer’s RJ-45 Modular Connector Serial RS-232 Connector