Direct-Thermal LP Model
Before following the steps in this procedure, open the printer by pulling the release latches forward then lifting the top cover.
Removal
1. Use a #1 Phillips driver to loosen the four screws that hold the latch frame to the top case.
2. Grasp the print head spring and pull it
to the left; then, slide it free of the latch frame.
3. | Gently pull the wire bundles from the |
| print head. |
4. | Use a #1 Phillips driver to loosen the |
| two screws and washers and release |
| the print head from the latch frame |
| and bracket. |
30 |
|
