Getting Ready to Print

Battery

Installing the Battery

NOTE: Batteries are shipped uncharged. Remove protective shrink-wrap and labels from new battery packs prior to use.

1.Rotate the Belt Clip to allow access to the Battery com- partment.

2.Insert the battery into the printer as shown in Figure 2,

3.Rock the Battery into the printer as shown until it locks in place.

When the battery is first installed, the Control Panel indicators may briefly turn on and then go off which indicates the battery is not fully charged (see “Charging the Battery” below and “Operator Controls”).

You must charge the batteries fully before using them for the first time. To ensure maximum battery capacity, new batteries should go through two or three complete charge/discharge

Figure 2: Installing the Battery

 

Battery

 

Belt Clip

Belt Clip

 

 

Charger Jack

 

QL 220

Battery

QL 320

Belt Clip

Charger Jack

QL 420

continued

11

QL Series User Guide