If you have a printer equipped with the Kickstand option, you must first remove the belt clip retainer as shown in Figure 14, retaining the two screws holding the retainer to the lower cov- er. Arrange the communications cable in a broad loop as detailed above, and capture it in the strain relief feature on the bottom of the belt clip retainer. Then re-secure the belt clip retainer to the bottom cover of the printer.

Figure 14: Communications Strain Relief with Kickstand option

Kickstand is not shown in this view for clarity

1. Remove Belt Clip Retainer, along with Belt Clip and Kickstand.

2. Press communications cable into strain relief feature on bottom of Belt Clip

3. Reassemble Belt Clip to bottom cover.

29

QL Series User Guide