Wireless Local Area Network (WLAN) Module Using CF Radio

The following section only applies when the CF (Compact Flash) WLAN module (With FCC ID: I28MD-RW4137) is installed in a QL Series printer (note that only one of the radio options can be installed in the printer at one time). The antenna used for this transmitter must not be co-located or must not operate in conjunction with any other antenna.

QL model printers have the FCC ID number label on the front of the module, and QL Plus models have the FCC ID number on a label on the back of the unit.

WARNING: Use of a QL Series printer with the radio module marked with FCC ID: I28MD-RW4137” meets the FCC requirements for radio frequency (RF) radiation exposure in the standard body worn configuration with no minimum separation. In this configuration, which applies whether the belt clip or shoulder strap is used, the face of the printer from which paper is transported is facing away from the user’s body. The standard configuration must always be used when the printer is body worn.

QL 220/220 Plus, QL 320/320 Plus and QL 420/420 Plus printers with this radio option have been SAR tested. The maximum SAR value measured for each model is listed below:

Model

SAR value W/Kg (1g average)

QL220/220 plus

0.0618

QL 320/320 plus

0.0500

QL 420/420 plus

0.0432

European Regulatory Information for this Radio

AT

BE

CY

CZ

DK

EE

FI

FR

DE

GR

HU

IE

IT

LV

LT

LU

MT

NL

PL

PT

SK

SI

ES

SE

GB

Note: -Member states in the EU with restrictive use for this device are crossed out!

This device is also authorized for use in all EFTA member states (CH, IS, LI, NO)

0336

 

Important Notice:

 

This device is a portable RF printer intended

 

for commercial and industrial use in all EU and

 

EFTA member states except in France where

 

restrictive use applies.

 

 

 

continued

33

QL Series User Guide