QL 320/320 Plus Wireless Local Area Network (WLAN) Module Using PCMCIA Radio

The following section only applies when the PCMCIA WLAN module (FCC ID: I28- QL320352) is installed in the QL 320 or QL 320 Plus printer (note that only one of the radio options can be installed in the printer at one time). The antenna used for this transmitter must not be co-located or must not operate in conjunction with any other antenna.

The FCC ID number label is on the front of the module for QL 320 and on the back label of QL 320 Plus. On all models the text can be read with the module installed.

WARNING: Use of the QL 320/320 Plus with the radio module marked with FCC ID: I28-QL320352 meets the FCC requirements for radio frequency (RF) radiation exposure in the standard body worn configuration with no minimum separation. In this configuration, which applies whether the belt clip or shoulder strap is used, the face of the printer from which paper is transported is facing away from the user’s body. The standard configuration must always be used when the printer is body worn. This configuration maintains the required 1 cm separation distance.

The printer with this radio option has been SAR tested. The maximum SAR value measured was .819 W/kg averaged over 1 gram.

European Regulatory Information for this Radio

AT

BE

CY

CZ

DK

EE

FI

FR

DE

GR

HU

IE

IT

LV

LT

LU

MT

NL

PL

PT

SK

SI

ES

SE

GB

Note: -Member states in the EU with restrictive use for this device are crossed out!

Important Notice:

0336 This device is a portable RF printer intended for commercial and industrial use in all EU and EFTA member states except in France where restrictive use ap- plies.

This device is also authorized for use in all EFTA member states (CH, IS, LI, NO)

continued

35

QL Series User Guide