4.Adjust the media supply guide and the media guide against the outer edge of the media. These guides must not cause pressure or excessive drag on the media.
5.Close the head open lever, and see “Adjusting the Media Sensor” on page 18 to adjust the media sensor position.
For loading fanfold media:
6.Refer to Figure 8. Make sure the fanfold media feeds through either the bottom (f) or rear (g) access slot.
NOTE: When utilizing the bottom access slot, be sure to thread media over the media supply hanger.
7.Thread the media through the printhead as shown in Figure 8.
8.Adjust the media supply guide and the media guide against the outer edge of the media. These guides must not cause pressure or excessive drag on the media.
9.Close the head open lever, and see “Adjusting the Media Sensor” on page 18 to adjust the media sensor position.
Figure 8. Loading — Fanfold Media
10 | Zebra S400 & S600 User’s Guide |
