Zebra Technologies S600, S400 manual OHDQLQJWKH&XWWHU0RGXOH

4.Observe the ends of the rear cutter blade guard and note the small metal pins protruding toward the inside. During the reassembly procedure, these pins are mounted into the corresponding mounting slots in the cutter side panels.

5.To provide complete access to the area to be cleaned, raise the upper cutter blade guard (c) as shown in Figure 20.

&OHDQLQJ￿WKH￿&XWWHU￿0RGXOH

1.Remove any label material that has adhered to the cutter parts and use a small brush to remove any paper dust from the cutter module.

2.If you use pressure-sensitive media, use a lint-free cloth soaked in an adhesive remover to remove all gum and label residue from the cutting blades and guards. If you use tag stock, use alcohol to remove any dirt.

5HDVVHPEOLQJ￿WKH￿&XWWHU￿0RGXOH

1.See Figure 21. Position the two wire springs (a) down against the lower cutter blade.

2.Place the rear cutter blade guard (b) over the wire springs, perpendicular to its final position. Place your thumbs on the top (flat) part of the guard.

NOTE: Ensure that the ends of the rear cutter blade guard are positioned on the outside of the cutter side panels.

3.Press the rear cutter blade guard down and forward, rotating the guard as you proceed, to lock the mounting pins (c) into position in the cutter side panel mounting slots (d). Slide the guard forward until the two wire spring loops pop up on the back side of the guard.

NOTE: Ensure that the wire springs remain positioned under the rear cutter blade guard when assembly is completed.

4.Lower the upper cutter blade guard back to its normal position. When reassembled, the back of the cutter module should look like the one shown in Figure 22.

Zebra S400 & S600 User’s Guide 35