'LVDVVHPEOLQJWKH&XWWHU0RGXOH
1.See Figure 20. Hold the cutter module as illustrated. Put your thumbs on the two wire spring loops (a) and your index fingers on the top of the rear cutter blade guard (b). It may help to lay the cutter module on a table or other surface throughout this process.
Figure 20. Cutter Module Disassembly
2.To remove the rear cutter blade guard, first press down simultaneously on the two wire spring loops. While pressing down on the loops, press the rear cutter blade guard back toward you and over the top of the loops. (You’re trying to tuck the loops underneath the blade guard in this process.)
3.Continue pressing the rear cutter blade guard toward you and allow the back edge of the guard to pop up as the guard comes free from its holders. You may now remove the rear cutter blade guard by lifting it off of the module.
NOTE: The wire springs may flip up out of position during this process. Springs are repositioned during reassembly.
34 | Zebra S400 & S600 User’s Guide |
