nal supply through the rear feed slot, between the media guides and up through the media compartment as shown. Make sure the side of the media you will be printing on faces the print head.

3. Close the Media Cover: Refer to Figure 9.

•If you plan to use the printer in the tear-off mode, close the media cover as shown at “2”, then rotate the latch as- sembly as shown until it locks into place, as shown at “4”.

•If you plan to use the printer in the peel-off mode, peel a few labels off of the media and pull it out of the printer as shown at “1”. Close the media cover as shown at “2”. Rotate the “EZ-Peel” peeler bar until it locks into place on the latch, as shown at “3”, then rotate the Latch as shown until it locks into place, as shown at “4”.

•Turn on the printer or press the Feed button if the printer is already on.

The printer will advance the media to the next label, if printing labels. If you are printing on journal media, the printer will advance a short strip of media.

Figure 9: Closing the Media Cover

Pull Media out of

Printer

Media Cover

“EZ-Peel” Peeler

Bar

Flip down if using media in the peel-off mode.

Latch

Assembly

22

QL Plus Series User Guide