Zenith XBS245 warranty Connections Basic TV Connections, Optional TV Connections

Connections (Continued)

Basic TV Connections

Make one of the following connections, depending on the capabilities of your TV.

RF coaxial connection

Connect the RF.OUT jack on the DVD+VCR to the antenna in jack on the TV using the 75-ohm Coaxial Cable supplied (R).

ote

If you use this connection, tune the TV to the DVD+VCR’s RF output channel (CH 3 or 4).

How to set the DVD+VCR’s RF output channel When the DVD+VCR is turned off, press and hold CH/PRESET (v/V) on the front panel for about five seconds to change the RF output channel (CH 03 or CH 04). “RF 03” or “RF 04” appears in the display win- dow.

Audio/Video connection

Connect the DVD/VCR VIDEO OUT jack on the

1 DVD+VCR to the video in jack on the TV using the supplied video cable (V).

2 Connect the Left and Right DVD/VCR AUDIO OUT jacks on the DVD+VCR to the audio left/right in jacks on the TV (A) using the supplied audio cables.

ote

If you use this connection, set the TV’s source selector to VIDEO.

Rear of TV

ANTENNA	AUDIO INPUT		VIDEO	COMPONENT/PROGRESSIVE			S-VIDEO
INPUT			INPUT		SCAN VIDEO INPUT		INPUT
	L	R	L	Pr	Pb	Y

R A V C S

Rear of DVD+VCR

Optional TV Connections

otes

DVD playback can ONLY be done using the S-VIDEO OUT and COMPONENT VIDEO OUT/PROGRESSIVE SCAN connection options below. The tuner and VCR will still output through the RF.OUT (R) or DVD/VCR OUT (A, V) jack. (See left)

When using the COMPONENT VIDEO OUT/PRO- GRESSIVE SCAN jacks, set the VIDEO OUTPUT switch to COMPONENT/PROGRESSIVE SCAN.

When using the S-VIDEO OUT jack, set the VIDEO OUTPUT switch to S-VIDEO.

S-Video Connection

1to the S-Video in jack on the TV using the supplied S-Video cable (S).Connect the S-VIDEO OUT jack on the DVD+VCR

2the DVD+VCR to the audio left/right in jacks on the TV using the supplied audio cables (A).Connect the Left and Right AUDIO OUT jacks on

Component Video (Color Stream®) connection

1GRESSIVE SCAN jacks on the DVD+VCR to the

corresponding in jacks on the TV using user-sup- plied Y Pb Pr cables (C).Connect the COMPONENT VIDEO OUT/PRO-

2the DVD+VCR to the audio left/right in jacks on the TV (A) using the supplied audio cables.Connect the Left and Right AUDIO OUT jacks of

Progressive Scan (ColorStream® pro) connection

If your television is a high-definition or “digital ready” television, you may take advantage of the DVD+VCR’s progressive scan output for the highest video resolution possible.

If your TV does not accept the Progressive Scan for- mat, the picture will appear scrambled if you try Progressive Scan on the DVD+VCR.

1PROGRESSIVE SCAN jacks on the DVD+VCR to

the corresponding in jacks on the TV using an optional Y Pb Pr cable (C).Connect the COMPONENT VIDEO OUT/

2the DVD+VCR to the audio left/right in jacks on the TV (A) using the supplied audio cables.Connect the Left and Right AUDIO OUT jacks of

otes

–Set the Progressive Scan to “On” on the DVD setup menu for progressive signal, see page 23.

–Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack).

12