Radio Operation

Presetting Radio Stations

You can preset 30 stations for FM and AM. Before tun- ing, make sure that you have turned down the volume to the minimum.

Press RADIO.

1 FM or AM appears in the display window and radio infor- mation appears on the TV screen.

2 Each time you press RADIO, you toggle between FM and AM.

3for about two seconds until the frequency indi- cation starts to change, then release.

Scanning stops when the DVD Receiver tunes in a

station. “STEREO” (for stereo program) appear in the dis- play window.Press and hold TUNING (v/V) on the front panel

Press MEMORY.

4 A preset number will flash in the display window.

5 Use TUNING (v/V) on the front panel to select the preset number.

Press MEMORY again.

6 The station is stored.

7Repeat steps 3 to 6 to store other stations.

To tune in a station with a weak signal

Press TUNING (v/V) repeatedly in step 3 to tune in the station manually.

To clear all the memorized stations

Press and hold MEMORY for about three seconds and “MEM CLEAR” appears in the display window and then press MEMORY again, the stations are cleared.

ote

If all stations have already been entered, MEM FULL message will appear in the display window for a moment and then a preset number will flash. To change the preset number, follow the steps 5-6 as above.

Listening to the Radio

Preset radio stations in the DVD+VCR’s memory first (see “Presetting radio stations” on the left side).

Press RADIO

1 FM or AM appears in the display window and radio information appears on the TV screen. The last received station is tuned in.

2 Press PRESET (v/V) repeatedly to select a pre - set station.

Each time you press the button, the DVD+VCR tunes in one preset station at a time.

3front panel or by pressing VOLUME + or – on the remote control repeatedly.Adjust the volume by rotating VOLUME on the

To turn off the radio

Press POWER to turn the DVD+VCR off or select another function mode (DVD, VCR, or AUX).

To listen to non-preset radio stations

Use manual or automatic tuning in step 2.

For manual tuning, press TUNING (v/V) on the front panel repeatedly.

For automatic tuning, press and hold TUNING (v/V) for about two seconds on the front panel.

For your reference

If an FM program is noisy

Press AUDIO so that “STEREO” disappears in the display window. There will be no stereo effect, but the reception will improve. Press the button again to restore the stereo effect.

To improve reception

Realign the antenna.

OPERATION

37

Page 37
Image 37
Zenith XBS245 Radio Operation Presetting Radio Stations, Listening to the Radio, To clear all the memorized stations