Zenoah HE225F, HEZ2500F manual Set up, HE225F HEZ2500F, English

English

6. Set up

SE1

[HE225F]

[HEZ2500F]

SE2

SE3

(A)

(B)

SE4

■MOUNTING ENGINE (SE1)

1.Push the driveshaft housing toward the clutch housing and rotate it by hand to check that the driveshaft is engaged with the gears.

2.Insert the driveshaft housing into the clutch housing until it bottoms, and align the positioning holes on the clutch housing and the shaft tube and install the screw. When difficult to engage, twist the engine slightly.

3.Fasten the clamp securely with two screws.

IMPORTANT

Tighten the screws(1) gradually by turns.

Tightning Torque: 44~70in-lbs (5~8N.m.)

■CONNECTING THROTTLE WIRE

1. Remove the air cleaner cover.

2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE2)

■CONNECTING SWITCH WIRES

•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.

■MOUNTING OTHER PARTS

1.Insert the driveshaft into the clutch drum, then attach the gearbox to the shaft tube as aligning the positioning holes and fasten the screw (A). Fasten the clamp bolt (B) firmly. (SE3)

(A)Screw

(B)Clamp bolt

(B)Tightning Torque: 52~69in-lbs (6~8N.m.)

2.Install the handle to the shaft tube and clamp at a position best for your job. (SE4)

18