ZyXEL Communications 100IH manual TCP/IP Remote Node Configuration, Only /Out Only, 2B/RIP-2M

Prestige 100 and 100IH ISDN Router and Router/Hub

	Table 5-2 TCP/IP Remote Node Configuration
Rem IP Address	This will show the IP address you entered for this remote node
	in the previous menu.
Rem IP Subnet	Enter the subnet mask for the remote network.
Mask
My WAN Addr	Some implementations, especially the UNIX derivatives,
	require the ISDN link to have a separate IP network number
	from the LAN and each end must have a unique address within
	the WAN network number. If this is the case, enter the IP
	address assigned to the ISDN port of your Prestige.
	Note that this is the address assigned to your local Prestige,
	not the remote router.
Single User	Set this field to Yes to enable the Single User Account feature	Yes/No
Account	for your Prestige. Use the space bar to toggle between Yes
	and No. See Chapter 3 - Internet Access Application for more
	information on the Single User Account feature.
Metric	The metric represents the “cost” of transmission for routing	1 to 15
	purposes. IP routing uses hop count as the measurement of
	cost, with a minimum of 1 for directly connected networks.
	Enter a number that approximates the cost for this link. The
	number need not be precise, but it must be between 1 and 15.
	In practice, 2 or 3 is usually a good number.
Private	This parameter determines if the Prestige will include the route	Yes/No
	to this remote node in its RIP broadcasts. If set to Yes, this
	route is kept private and not included in RIP broadcast. If No,
	the route to this remote node will be propagated to other hosts
	through RIP broadcasts.
RIP	Press the space bar to select the RIP direction from Both/In
	Only/Out Only.	(Default=Both)
Version=	Press the space bar to select the RIP version from RIP-1/RIP-	RIP-1(default)
	2B/RIP-2M.

Once you have completed filling in the Network Layer Options Menu, press [Enter] to return to Menu 11. Press [Enter] at the message [Press ENTER to Confirm...] to save your configuration, or press [Esc] at any time to cancel.

5-4 Remote Node TCP/IP Configuration