Prestige 304 Broadband Sharing Gateway with 4-Port Switch

2.2.4 LAN 10/100M Connections/Uplink Button Usage at a Glance

Table 2-2 Ethernet Cable Requirements for LAN 10/100M Port Connections

 

LAN 10/100M

TYPE OF ETHERNET CABLE FOR CONNECTING THE

 

PORT NUMBER

 

PRESTIGE TO A …

 

 

COMPUTER

 

HUB

 

 

 

 

 

1

 

straight-through

 

crossover

 

 

 

 

 

2

 

straight-through

 

crossover

 

 

 

 

 

3

 

straight-through

 

crossover

 

 

 

 

 

4

UPLINK button “on”

straight-through

 

crossover

 

 

 

 

 

4

UPLINK button “off”

crossover

 

straight-through

 

 

 

 

 

2.2.5 POWER 5VDC Port

Connect the female end of the power adapter to the port labeled POWER 5VDC on the rear panel of your Prestige.

To avoid damage to the Prestige, make sure you use the correct power adapter.

Refer to the Power Adapter Specification Appendix for this information.

2.2.6 RESET Button

Refer to section 2.5 for information on the RESET button.

2.3Additional Installation Requirements

1.A computer(s) with an installed Ethernet NIC (Network Interface Card).

2.A cable/xDSL modem and an ISP account.

2.4Turning on Your Prestige

At this point, you should have connected the LAN port(s), the WAN port and the POWER port to the appropriate devices or lines. Plug the power adapter into an appropriate power source.

The SYS LED turns on. The WAN LED and the LAN LED (s) turn on after the system tests are complete if proper connections have been made to the LAN and WAN ports.

2-4

Hardware Installation