ES-2000 Series Switch Support Notes
Load Factory Defaults
From Web GUI:
1.Click Management and then Maintenance in the navigator panel to bring up the following screen.
2.Click on the “Click Here” button of the Load Factory Defaults to bring up the following screen.
3.A dialog pops up with the message “Are you sure you want to load factory defaults?”.
4.Click OK to go to the following dialog.
5.Click on the OK button. Now, all switch configurations has been reset to the factory defaults and the system will be restarted.
6.Please note that the switch IP address is now 192.168.1.1.
From Console Port:
1.Connect to the console port and open the Terminal Emulation Software.
2.Type in the correct password to bring up the prompt. Type “erase run” to load the factory default configurations.
10
All contents copyright (c) 2006 ZyXEL Communications Corporation.
