Nokia DNT2Mi sp/mp user manual Time slot use 6,5, Default settings 6,6, Factory settings 6,7

Data Network Terminal Single-port and Multiport Operating Instructions

9.3.6Time slot use (6,5)

The mapping of time slots can be viewed and configured via this menu (see

Figure 63).

The format of the display showing the current use of the time slots is as follows:

•Time slots can be freely selected between the ports.

•Time slots can be reserved only if they are not in use. Otherwise, they must be first removed from the time slot map.

Mapping is performed between the line and ports, that is, you can reserve time slots required for each port from the line, and the number of time slots defines the speed used at the port (see Figure 80, TS use in line). Time slots can be reorganised using the G.704 adapter (see Figure 80, TS mapping in Port 1-3).

9.3.7Default settings (6,6)

The default settings are stored in the EEPROM. When installing DNT2Mi, the settings can be changed using the front panel menus or Q1 management (see Figure 63). Refer to Section 6.9 for the default values.

The default settings can be set separately to each DNT2Mi port and line. Selecting the option 9 (All) returns all default settings into use except for service options, that is, the Q1 speed and address.

To activate the settings, you have to answer 99 (Yes) after receiving a request for confirmation. It takes about 60 seconds to save the information. If the power is switched off during this time, factory settings will be written into the EEPROM. During the saving process, you can use the equipment normally.

If you answer 1 (Cancel), the default settings will not be taken into use.

9.3.8Factory settings (6,7)

Factory settings can be loaded by using this menu (see Figure 63).

With this setting, it is possible to reset the EEPROM and to restore default structures and settings into use. Refer to Sections 6.9 and 6.10 for the default and factory values.

To activate the settings, you have to answer 99 (Yes) after receiving a request for confirmation. It takes about 60 seconds to save the information.

If you answer 1 (Cancel), the factory settings will not be taken into use.

112 (128)	© Nokia Corporation	DN01145897
	Nokia Proprietary and Confidential	Issue 2-0 en