Nokia DNT2Mi sp/mp Global parameters Continued, Line parameters, Multiplexer parameters

Commissioning DNT2Mi

Table 5. Global parameters (Continued)

Use of front panel keys	In use
Q1 rate *)	4800 bit/s

*) = Recalling the default values does not change the values set for the Q1 management parameters. The original values for these parameters can be recalled by recalling the factory settings, refer to Section 6.10.

Table 6.	Line parameters
Line interface		STU-R rate adaptive, 2-wire
Power backoff		ON
Bit error alarm limit		10-6

Table 7. Multiplexer parameters

Use of time slots

No time slots connected

Table 8.	Port parameters, V-series (V.11, V.28, V.35 or EIA-530-A)
Port rate		n x 64k (n=1)
Use of V.110 rate adaptation in		Not in use
port 2 or 3
In port 2 or 3		9600 kbit/s, Synchronous
Remote loop detection		Allowed
Externally caused alarms		Disabled (not to be seen through Q1).
		However, even if these alarms are disabled, they
		cause front panel alarms.
Rx timing (CT103)		DCE source (CT114)
CTS use		Not in use
CTS		On
DCD		Follows line synchronisation
DSR		On
Circuit 140		Disabled
Circuit 141		Disabled

DN01145897	© Nokia Corporation	45 (128)
Issue 2-0 en	Nokia Proprietary and Confidential