Nokia DNT2Mi sp/mp user manual CTS use 6,4, port #,3,3,1, DCD use 6,4, port #,3,3,2

Using Q1 menus

-CTS use (6,4, port #,3,3,1)

The suboptions of the menu allow you to:

•display the current use of the circuits

•set the CTS (106) circuit ON

•make the CTS circuit follow the RTS (105) circuit with a 8- bit delay in transition from the OFF state to the ON state

•make the CTS circuit follow the RTS circuit with a 255-bit delay in transition from the OFF state to the ON state

•set the RTS circuit to control the DCD (109) circuit at the remote end (Simulated carrier).

-DCD use (6,4, port #,3,3,2)

The suboptions of the menu allow you to:

•display the use of the DCD circuit

•set the DCD circuit to follow the synchronisation of the line (frame sync on −> DCD on)

•set the DCD circuit to follow the simulated carrier signal (V.13).

-DSR & DTR use (6,4, port #,3,3,3)

The suboptions of the menu allow you to:

•display the current use of the DSR (107) and DTR (108) circuits

•set the DSR circuit to follow the state of the DTR circuit

•set the DSR circuit to ON state, the DTR circuit not being in use.

-CT140 use (6,4, port #,3,3,4)

The suboptions of the menu allow you to:

•display the current use of circuit 140

•enable or disable circuit 140 to control the remote loop to line.

-CT141 use (6,4, port #,3,3,5)

The suboptions of this menu allow you to:

•display the current use of circuit 141

•enable or disable circuit 141 to control the local loop.

G.704/2M-type interface settings (6,4, port #,3)

•Framing format (6,4, port #,3,1)

The use of the G.704 framing can be selected or its use can be prevented using this menu (see Figure 65). The selections are:

-No frame

-Basic frame

-CRC multiframe

DN01145897	© Nokia Corporation	109 (128)
Issue 2-0 en	Nokia Proprietary and Confidential