Chapter 9 The VPN Transport Screens
User’s Guide
106
9.4.1 Ethernet Pseudowire Setup
Click a pseudowire entry’s Edit icon in the ADVANCED > VPN Transport >
Ethernet Pseudowire screen to set up or modify an Ethernet pseudowire’s
configuration.

Figure 42 ADVANCED > VPN Transport > Ethernet Pseudowire Setup

The following table describes the labels in this screen.
Ingress This is the MPLS virtual circuit label number for traffic coming
from the peer device.
Egress This is the MPLS virtual circuit label number for traffic going to the
peer device.
Pseudowire
Description This displays the information you previously entered describing
the pseudowire.
Action Click the Edit icon to set up an Ethernet pseudowire or alter the
configuration of an existing Ethernet pseudowire.
Click the Delete icon to remove an existing Ethernet pseudowire.

Table 29 ADVANCED > VPN Transport > Ethernet Pseudowire (continued)

LABEL DESCRIPTION

Table 30 ADVANCED > VPN Transport > Ethernet Pseudowire Setup

LABEL DESCRIPTION
Active Select this to enable the pseudowire. Deselect it to disable the
pseudowire.
MPLS VC Label
Ingress Enter the VC ingress label number for this pseudowire. This must
be the egress label number of the peer device. This should not
be the ingress label number of any other Ethernet pseudowire
configured on the WiMAX Modem.
Egress Enter the egress label number for this pseudowire. This must be
the ingress label of the peer device. This should not be the
egress label number of any other Ethernet pseudowire
configured on the WiMAX Modem.