Barco R9001390 manual Change Password, How to enable or disable the password function ?

Service Mode

Change Password

This item is password protected when the password strap is installed.

How to enable or disable the password function ?

The password function is enabled when the password strap on the controller module is installed.

To get access to the controller module, proceed as follows :

-Power down the projector and disconnect the power cord from the wall outlet.

-Turn both lock screws on the side of the front top cover with a screwdriver or coin counter clockwise.

-Lift up and pivot the top cover. Attention : the cover is not secured with an incorporated support. When opening, turn it over slowly and lay it down on the second part of the top cover.

Loosen the locking screws.

0 I

	PROJECTORMODE :
	GREEN - OPERATION	DIAGNOSTICS
COMMUNICATION PORT	RED - STANDBY	IR-ACKNOWLEDGED CODE	IR-RECEIVER

RS232 OUT RS232 IN (800-PERIPHERALS) REMOTE

IR-RECEIVED

R

G

B

H

V

R

G

B

H / C

V

R

G

B

H / C

V

27910

On

98

Open the top cover

When the strap is on leg 2-3 or no strap is mounted, the password function is enabled, when the strap is on leg 1-2, the password function is disabled.

0 I

	PROJECTORMODE :
	GREEN - OPERATION	DIAGNOSTICS
COMMUNICATION PORT	RED - STANDBY	IR-ACKNOWLEDGED CODE	IR-RECEIVER

RS232 OUT RS 232 IN (800-PERIPHERALS) REMOTE

IR-RECEIVED

R

G

B

H

V

R

G

B

H / C

V

R

G

B

H / C

V

9827910

On

Password enabled	Password disabled
strap on leg 2-3	strap on leg 1-2

How to change the password ?

Highlight Change password by pushing the control disc up or down and press ENTER to display the Change Password menu.

ENTER displays the Change Password menu

EXIT returns to the adjustment selection menu.

ADJUST returns to operational mode.

The old password is displayed and can be changed by entering the digit with the numeric keys of the RCU or local keypad.

Press ENTER to save the new entered password. Press EXIT if no changes have to be made.

SERVICE

IDENTIFICATION

CHANGE PASSWORD CHANGE LANGUAGE

CHANGE PROJ. ADDRESS CHANGE BAUDRATE PC RESET LAMP RUNTIME LAMP RUNTINE HISTORY

LAMP DRIVE MODE

MORE...

Select with	or
then <ENTER>
<EXIT> to	CHANGE PASSWORD
	Enter new	password
	0000
	Select with	or
	then <ENTER>
	<EXIT> to	return.

5975938 BARCOREALITY 9200TCR+ 020798 10-3