Controlling
6CONTROLLING
The projector can be controlled with a. The RCU
b. The hardwired RCU (cable is not included) c. The local keypad.
Controlling the projector with the RCU and the hardwired RCU is equal.
How to Use the RCU?
a) Point the front of the RCU to the reflective screen surface.
Ceiling
IR sensor
Screen
c)Point the front of the RCU directly at one of the IR sensors of the projector.
IR sensor | IR sensor |
0 I |
Table | Rear of projector |
Front of projector
RCU
45° | 45° | 45° | 45° |
90
7 8 |
| RCU | 9 | 0 |
|
|
|
|
| ||||
|
|
| ||||
5 6 |
|
|
|
| ||
3 4 |
| 5 6 |
|
| ||
1 2 |
|
| 7 | 8 |
| RCU |
|
| 3 4 |
| |||
|
| 1 2 |
|
| ||
|
|
|
|
| ||
|
|
|
|
| ||
When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft in a straight line). The remote control unit will not function properly if strong light strikes the sensor window or if there are obstacles between the remote control unit and the projector IR sensor.
b) RCU used in a hardwired configuration.
0 I |
|
|
|
|
|
|
|
|
| PROJECTOR MODE: |
|
|
|
|
|
| GREEN | DIAG NOSTICS |
| |
RS232 OUT | RS 232 IN | COMMUNICATION PORT | RED - STANDBY | CODE | ||
REMOTE |
|
|
| |||
|
|
|
|
|
| |
|
|
|
|
|
| 9827910 |
Plug one end of the remote cable in the connector on the bottom of the RCU and the second side in the connector in the front panel of the projector labelled 'REMOTE'.
Projector Address
a. Software Set up of the Projector Address.
See 'Change projector address' in chapter 'Service mode'.
b. How to Control the Projector or Projectors.
Every projector requires an individual address between 0 and 255 which can be set in the Service mode.
When the address is set, the projector can be controlled now :
-RCU for addresses between 0 and 9.
-Computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between 0 and 255.
Note : A projector will respond to a RCU set to an address of '0' regardless of what address is set in the projector itself.
c. Using the RCU.
Before using the RCU, its is necessary to enter the projector address into the RCU (only when that address is between 0 and 9). The projector with the corresponding address will listen to that specific RCU.
When address 0, <zero> is programmed into the RCU, every projec- tor, without exception will listen to the commands given by this RCU.
5975938 BARCOREALITY 9200TCR+ 020798 |
| |
|
