Green to Midposition, Green Focusing, Installation Mode

Installation Mode

Green to Midposition

Only in case all panels have been removed and replaced by others or when the convergence is totally misaligned.

For normal convergence adjustment, this step can be skipped.

To set Green in Midposition, highlight 'Green to midposition' by pushing the control disc up or down and press ENTER to select.

A warning will be displayed :

"Are you sure to set the green motorized convergence adjustment to midposition ? This adjustment cannot be undone afterwards !".

If you are sure, press ENTER to continue, otherwise press EDIT to cancel.

Remark : While 'Green to midposition' is in progress, a clicking sound may be heard, caused by the end of adjustment motor protection.

1Highlight 'Green' by pushing the Control disc up or down and press

ENTER

2Adjust the projection lens until optimal focus on position 3 is obtained.

hint : use the focusing marker lines next to the digit.

3Adjust position 1 for optimal focus.

4 Adjust position 2 for optimal focus.

5 Adjust position 3 for optimal focus.

6Repeat step 3, 4 and 5 one time as these three alignments influence each other slightly.

GREEN TO MIDPOSITION

GREEN

BLUE ON GREEN

RED ON GREEN

HATCH

ABOUT MOCA

Are you sure to set the green motorized convergence adjustment to midposition ?

This adjustment cannot be undone afterwards !

<ENTER> to continue

<EXIT> to cancel

1Highlight 'Blue on Green' by pushing the Control disc up or down and press ENTER to display the Blue on green test pattern.

The drawings and digits will be displayed in blue.

2Adjust position 1, 2 and 3 to obtain an optimal focus for these lines.

3 Due to interaction, it will be necessary to repeat step 2.

4Adjust position 4 and 5 for optimal convergence of the lines in 4 and 5.

5Adjust position 6 for optimal convergence of the vertical lines in 6.

6 Check if all lines are correctly converged.

5975938 BARCOREALITY 9200TCR+ 020798		9-3