Connections
Lamp Run Time
When the total run time of the lamp is 970 hours or more, the following warning message will be displayed for 1 minute. This warning message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.
When the total run time of the lamp is 1000 hours or more, the following warning message, with the exact run time is displayed on the screen.
Lamp run time is 1000 hours. Operating the lamp longer than 1000 hours may damage the projector. Please replace the lamp.
When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.
The total lifetime of the lamp for a safe operation is 1000 hours max. Do not use it longer. Always replace with a same type of lamp. Call a BARCO authorized service technician for lamp replacement.
Warning : Using a lamp for more than 1000 hours is dangerous as the lamp could explode.
Lamp run time 980 h
WARNING
Lamp run time is 1000 hours Operating the lamp longer
than 1000 hours may damage 
the projector. 
Please replace the lamp
<ENTER> to continue
Switching to Stand-by.
When the projector is running and you want to go to
Input Connections.
The projector has three fixed and two modular input facilities. The modular input slots (slot 3 and 4) can be filled up with the following modules :
Video, | order no. : R9827900 |
RGBS/RGsB analog input | order no. : R9827910 |
RGB3S/RG3sB input | order no. : R9827920 |
Component Video | order no. : R9827930 |
The sequence of insertion has no importance. Duplicated inputs can be used.
Note : When using a RCVDS05 or VS05, the input configu- ration of the projector must be as follows:
Slot 1 : not used
Slot 2 : RGB and Component video input
Slot 3 : Video input module
Slot 4 : not used
When using a RCVDS05, it is recommended to use a
To switch the projector in the
Input module insertion into the projector :
-Power down the projector and disconnect the power cord from the wall outlet.
-Remove the dummy plate covering the chosen input slot by turning out both screws.
-Slide the input module in the free slot. Insure the module is seated correctly in the guide grooves.
-Press on both handles of the input module until the module plug seats in the connector of the projector.
-Secure the input module by tightening both retaining screws.
Switching Off
To switch off:
-First press STANDBY key and let the projector cool down until the fans stop blowing, or at least 15 min.
-Switch off the projector with the power switch.
WARNING : When switching to standby, never restart the projector (hot restrike) within the first 3 minutes to avoid damage to the lamp.
0 I |
|
|
|
|
|
| DIA GNOSTICS |
| |
|
| CODE | ||
RS232 OUT | RS 232 IN | REMOTE |
|
|
|
|
|
| |
|
|
|
| 98 27910 |
-Reconnect the power cord to the wall outlet and switch on the projector.
The new installed module can be selected with the digit buttons on the RCU or the local keypad.
5975938 BARCOREALITY 9200TCR+ 020798
