Barco R9001390 manual Battery installation in the RCU

Unpacking and Dimensions

Battery installation in the RCU.

A battery (not yet installed to save the battery life time) is delivered inside the plastic bag with the power cord. To install the battery, remove the battery cover on the backside of the remote control by pushing the indicated handle a little towards the bottom of the RCU. Lift up the top side of the cover at the same time (fig. 1).

Insert the new 9 V battery (type E-block or equivalent) in the lower compartment and connect the battery to the contact plate.

Insert the battery into the lower compartment and put the cover back.

Note : projector address has to be programmed on the RCU before using the RCU (see chapter 'Controlling').

Contact plate

Battery

fig.1

Insert here the 'Insert card RCU' which you can cut out on the last page of this manual.

fig.2

310a.DRW

1-2 5975938 BARCOREALITY 9200TCR+ 020798