Identification, Software version, Service Mode

Service Mode

SERVICE

IDENTIFICATION

CHANGE PASSWORD CHANGE LANGUAGE CHANGE PROJ. ADDRESS CHANGE BAUDRATE PC RESET LAMP RUNTIME LAMP RUNTINE HISTORY LAMP DRIVE MODE MORE...

Select with or then <ENTER> <EXIT> to return.

PANEL ADJUSTMENT

Select the

color temperature

PROJECTOR WHITE

6500

Select with or then <ENTER> <EXIT> to return.

PRESET INPUT BALANCE

WHITE BALANCE

BLACK BALANCE

DEFAULT

Select with <ENTER>

<EXIT> to return

Adjust

red with or

blue with or

SERVICE

BARCO LOGO

PANEL ADJUSTMENTS

PRESET INPUT BALANCE

I2C DIAGNOSIS

MORE...

Select with or then <ENTER> <EXIT> to return.

BARCO LOGO

STATUS :

BACKGROUND :

SHIFT

HOT KEY :

Select with or <ENTER> to toggle/select <EXIT> to return.

I2C DIAGNOSIS
			D CA
LCD DRIVER	SC76013	E4H # # #
LCD DRIVER	SC76013	E6H # # #
LCD DRIVER	SC76013	E8H # # #
LCD DRIVER	SC76013	EAH # # #
INPUT SELECT	TDA8444	46H	# # #
INPUT SELECT	PCF8574A 7EH # # #
DECODER	87C751	12H	# # #
LAMP DRIVER	PCF8574A	72H	# # #
POWER SUPPLY 87C752		10H	# # #

Identification

To display the Identification screen, push the control disc up or down to highlight Identification and press ENTER to display the Identifica- tion screen.

The Identification screen gives an overview of :

-type of projector

-projector address

-software version

-installation configuration

-baud rate

-text ON

-projector serial number

-projector run time

-type of projector : BARCOREALITY 9200 TCRPLUS

-software version

-Proj. Address : to change the address of the projector, see Change Projector Address in this chapter.

-Installation : possible installations :

*Front/Ceiling

*Front/Table

*Rear/Ceiling

*Rear/Table

To change the installation configuration follow the instructions in chapter Installation Set Up.

-Baud rate : transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must be the same as the baud rate of the connected computer. When there is a difference, consult 'Change Baudrate PC' in this chapter.

-Projector Run Time : gives the total run time since the first start up. All projectors leave the factory with a run time of approximately 24 hours.

-Projector Serial number : indicates the fabrication number of the projector. This number can be useful when calling for technical assistance.

SERVICE

IDENTIFICATION