2.2.1 Using the Reset Button
1Make sure the PWR/SYS LED is on (not blinking).
2Press the RESET button for ten seconds or until the PWR/SYS LED begins to blink and then release it. When the PWR/SYS LED begins to blink, the defaults have been restored and the Prestige restarts.
2.3Navigating the Prestige Web Configurator
The following summarizes how to navigate the web configurator from the SITE MAP screen.
•Click Wizard Setup to begin a series of screens to configure your Prestige for the first time.
•Click a link under Advanced Setup to configure advanced Prestige features.
•Click a link under Maintenance to see Prestige performance statistics, upload firmware and back up, restore or upload a configuration file.
•Click SITE MAP to go to the Site Map screen.
•Click Logout in the navigation panel when you have finished a Prestige management session.
Figure 5 Web Configurator: Site Map Screen
Note: Click the 
icon (located in the top right corner of most screens) to view embedded help.
Table 3 Web Configurator Screens Summary
LINK | FUNCTION | |
|
|
|
Wizard Setup | Connection | Use these screens for initial configuration including general |
| Setup | setup, ISP parameters for Internet Access and WAN IP/DNS |
|
| Server/MAC address assignment. |
Advanced Setup |
|
|
|
|
|
Password |
| Use this screen to change your password. |
|
|
|
LAN |
| Use this screen to configure LAN DHCP and TCP/IP settings. |
|
|
|
Chapter 2 Introducing the Web Configurator | 42 |