ZyXEL Communications wireless active fiber router Front Panel LEDs and WPS Button, Color, Status

Chapter 2 The WPS Button

The following table describes the LEDs and the WPS button.

Front Panel LEDs and WPS Button

LED	COLOR	STATUS	DESCRIPTION
Power	Green	On	The FSG1100HN is receiving power and
			functioning properly
		Off	The FSG1100HN is not receiving power.
	Red	On	A system error has occurred.
WAN	Green	On	The FSG1100HN has a successful
			10/100Mbps WAN connection.
		Blinking	The FSG1100HN is sending/receiving data
			through the WAN.
		Off	The WAN connection is not ready, or has
			failed.
WLAN/WPS	Green	On	The FSG1100HN is ready, but is not
			sending/receiving data through the wireless
			LAN.
		Blinking	The FSG1100HN is sending/receiving data
			through the wireless LAN.
			The FSG1100HN is negotiating a WPS
			connection with a wireless client.
		Off	The FSG1100HN is not ready or has failed.
	Orange	Blinking	The FSG1100HN’s WPS connection is being
			configured.
Internet	Green	On	The FSG1100HN’s IP is connected (the
			device has a WAN IP address from IPCP or
			DHCP and fiber is linked or a static IP
			address is configured, PPP negotiation has
			successfully completed – if used – and fiber is
			linked) and no traffic is detected. If the IP or
			PPPoE session is dropped due to an idle
			timeout, the light will remain green if a fiber
			connection is still present. If the session is
			dropped for any other reason, the light is
			turned off. The light will turn red when it
			attempts to reconnect and DHCP or PPPoE
			fails.
		Blinking	The FSG1100HN’s IP is connected and IP
			traffic is passing through the device (either
			direction), flashing at 4 Hz with a 50% duty
			cycle.

FSG1100HN User’s Guide

17