Husqvarna Automower manual Installation and connecting the charging station

Page 21

3. Installation

Do not put the charging station in a corner or pocket in the working area.

Avoid placing the charging station in a narrow passage (narrower than about 10 ft).

Installation and connecting the charging station

1.Position the charging station in a suitable spot.

2.Secure the charging station to the ground using the supplied nails.

IMPORTANT INFORMATION

It is not permitted to make new holes in the plate. Only the existing holes may be used to secure the plate to the ground.

3012-513

3012-514

3012-515

3012-549

Automower from

™ 21

Image 21

Contents Operator’s manual Page Table of contents Table of contents Introduction Introduction and safetySymbols on Automower Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualUse Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Function of Automower CapacityMowing technique Working method 3012-388 3012-700 3012-400 Search method Movement patternSearch method 1 Irregular Search method 2 Follow loop Search method 3 Follow guide wireOne Automower in several gardens More than one Automower in a gardenCarry out the installation in the following steps InstallationInstallation of the charging station PreparationsIdeal position of the charging station Transformer is for indoor use only Low voltage cable must not be extendedInstallation and connecting the charging station Do not tread or walk on the charging station plate Charging the battery Installation of the boundary wireBest position for the boundary wire Boundaries for the working area 3012-716 Secondary areas Boundaries within the working areaPassages when searching for the charging station Passages when mowingSlopes Laying out the boundary wire Laying the boundary wire in towards the charging station Joining the boundary wire Connecting the boundary wire3012-508 Checking the installation Installation of the guide wire Need of a guide wireLinking the Automower to the charging station Boundary wire runs along a steep slope steeper than 35 % Placement and connection of the guide wire If you shall install the guide wire through a passage 3012-675 Use Charging a discharged batteryUsing the timer Starting the AutomowerStopping the Automower Restart Switching off the AutomowerRestart within 20 seconds Restart after more than 20 secondsCutting height can be varied from MIN 0.8 to MAX Adjusting the cutting heightControl panel Shortcuts Select ProgramsNumbers Main switchMain menu Menu functionsBrowse between menus Number seriesAutomower Automower main menuTimer CommandsTimer override Day timerWeekend timer Week timer GardenMon Tue Wed Thu Fri Sat Sun Run all Exit angles Follow loop Proportion firstFollow loop out Direction DistanceProportion Follow loop Corridor width When Test in 3-2-4 is used, the house icon TestTest OUT Open Garden shapeNormal ComplexDrive past wire AdvancedCheck loop Security SettingsPIN code Time lockStop protection Sounds Settings lockOperation KeypadSound Significance LanguageTime and date Garden example proposed installation and settings Proposals for installation and settingsGarden shape Open Corridor width Guide wire Garden shape Normal Garden shape Complex 3012-732 Maintenance Service BatteryWinter storage AutomowerCleaning After winter storageUnderframe and blade disc Chassis Replacing the bladesWheels Body3012-260 Fault messages Trouble shootingDocked correctly in the charging Results Symptom Cause Action Uneven mowingAutomower runs at Wrong timeTechnical data Environmental InformationData Automower from Husqvarna Environmental information Environmental information Auto IndexGuide wire Delay Installation Guide wire delay Home Symbols Automower Operator’s manual Symptom cause and action Transport Automower from 2005W48