Husqvarna Automower manual Do not tread or walk on the charging station plate

Page 22

3. Installation

3.Connect the low voltage cable to the charging station.

Only use original cable and transformer.

4.Connect the low voltage cable to the transformer.

The connectors may be slightly difficult to connect, as they are moisture-proof.

5.Connect the transformer’s power cord to a 120V wall socket. It is preferable to use an earth-fault breaker as recommended.

IMPORTANT INFORMATION

Do not tread or walk on the charging station plate.

22 Automower from ™

3012-263

3012-262

3012-533

Image 22

Contents Operator’s manual Page Table of contents Table of contents Introduction and safety IntroductionSymbols on Automower Symbols in the Operator’s Manual Xxxxxx xxxxx xxxx xxxx xxxxxSafety instructions UseMaintenance TransportPresentation Automower, what’s what? Numbers in the picture correspond toCapacity Function of AutomowerMowing technique Working method 3012-388 3012-700 3012-400 Movement pattern Search methodSearch method 1 Irregular Search method 3 Follow guide wire Search method 2 Follow loopMore than one Automower in a garden One Automower in several gardensInstallation Carry out the installation in the following stepsPreparations Installation of the charging stationIdeal position of the charging station Low voltage cable must not be extended Transformer is for indoor use onlyInstallation and connecting the charging station Do not tread or walk on the charging station plate Installation of the boundary wire Charging the batteryBest position for the boundary wire Boundaries for the working area 3012-716 Boundaries within the working area Secondary areasPassages when mowing Passages when searching for the charging stationSlopes Laying out the boundary wire Laying the boundary wire in towards the charging station Connecting the boundary wire Joining the boundary wire3012-508 Checking the installation Need of a guide wire Installation of the guide wireLinking the Automower to the charging station Boundary wire runs along a steep slope steeper than 35 % Placement and connection of the guide wire If you shall install the guide wire through a passage 3012-675 Charging a discharged battery UseStarting the Automower Using the timerStopping the Automower Restart within 20 seconds Switching off the AutomowerRestart Restart after more than 20 secondsAdjusting the cutting height Cutting height can be varied from MIN 0.8 to MAXControl panel Shortcuts Programs SelectMain switch NumbersBrowse between menus Menu functionsMain menu Number seriesAutomower main menu AutomowerCommands TimerDay timer Timer overrideWeekend timer Garden Week timerMon Tue Wed Thu Fri Sat Sun Run all Exit angles Proportion first Follow loopFollow loop out Distance DirectionProportion Follow loop Corridor width Test When Test in 3-2-4 is used, the house iconTest OUT Normal Garden shapeOpen ComplexAdvanced Drive past wireCheck loop PIN code SettingsSecurity Time lockStop protection Operation Settings lockSounds KeypadLanguage Sound SignificanceTime and date Proposals for installation and settings Garden example proposed installation and settingsGarden shape Open Corridor width Guide wire Garden shape Normal Garden shape Complex 3012-732 Maintenance Winter storage BatteryService AutomowerAfter winter storage CleaningUnderframe and blade disc Wheels Replacing the bladesChassis Body3012-260 Trouble shooting Fault messagesDocked correctly in the charging Automower runs at Symptom Cause Action Uneven mowingResults Wrong timeEnvironmental Information Technical dataData Automower from Husqvarna Environmental information Environmental information Index AutoGuide wire Delay Installation Guide wire delay Home Symbols Automower Operator’s manual Symptom cause and action Transport Automower from 2005W48