Husqvarna Automower manual 3012-508

Page 32

3. Installation

2.Slide in the ends of the boundary wire in the lowermost holes on the charging station and catch them in the uppermost holes.

The right hand wire end should be inserted in the right hand hole, and the left hand wire end in the left hand hole.

IMPORTANT INFORMATION

The boundary wire must not be crossed when connecting to the charging station. Therefore the right hand wire end must be connected to the right hand connector on the charging station and vice versa.

3.Place the cable ends in the connector:

•Open the connector.

•Place the wire in the connector grip.

4.Press the connector together using a pair of pliers. Press until you hear a click.

3012-508

3012-506

3012-284

3012-264

32 Automower from ™

Image 32

Contents Operator’s manual Page Table of contents Table of contents Introduction and safety IntroductionSymbols on Automower Symbols in the Operator’s Manual Xxxxxx xxxxx xxxx xxxx xxxxxSafety instructions UseMaintenance TransportPresentation Automower, what’s what? Numbers in the picture correspond toMowing technique Function of AutomowerCapacity Working method 3012-388 3012-700 3012-400 Search method 1 Irregular Search methodMovement pattern Search method 3 Follow guide wire Search method 2 Follow loopMore than one Automower in a garden One Automower in several gardensInstallation Carry out the installation in the following stepsIdeal position of the charging station Installation of the charging stationPreparations Low voltage cable must not be extended Transformer is for indoor use onlyInstallation and connecting the charging station Do not tread or walk on the charging station plate Best position for the boundary wire Charging the batteryInstallation of the boundary wire Boundaries for the working area 3012-716 Boundaries within the working area Secondary areasPassages when mowing Passages when searching for the charging stationSlopes Laying out the boundary wire Laying the boundary wire in towards the charging station Connecting the boundary wire Joining the boundary wire3012-508 Checking the installation Linking the Automower to the charging station Installation of the guide wireNeed of a guide wire Boundary wire runs along a steep slope steeper than 35 % Placement and connection of the guide wire If you shall install the guide wire through a passage 3012-675 Charging a discharged battery UseStopping the Automower Using the timerStarting the Automower Switching off the Automower RestartRestart within 20 seconds Restart after more than 20 secondsAdjusting the cutting height Cutting height can be varied from MIN 0.8 to MAXControl panel Shortcuts Programs SelectMain switch NumbersMenu functions Main menuBrowse between menus Number seriesAutomower main menu AutomowerCommands TimerWeekend timer Timer overrideDay timer Mon Tue Wed Thu Fri Sat Sun Run all Week timerGarden Exit angles Follow loop out Follow loopProportion first Proportion DirectionDistance Follow loop Corridor width Test OUT When Test in 3-2-4 is used, the house iconTest Garden shape OpenNormal ComplexCheck loop Drive past wireAdvanced Settings SecurityPIN code Time lockStop protection Settings lock SoundsOperation KeypadLanguage Sound SignificanceTime and date Garden shape Open Garden example proposed installation and settingsProposals for installation and settings Corridor width Guide wire Garden shape Normal Garden shape Complex 3012-732 Maintenance Battery ServiceWinter storage AutomowerUnderframe and blade disc CleaningAfter winter storage Replacing the blades ChassisWheels Body3012-260 Trouble shooting Fault messagesDocked correctly in the charging Symptom Cause Action Uneven mowing ResultsAutomower runs at Wrong timeData Automower from Husqvarna Technical dataEnvironmental Information Environmental information Environmental information Index AutoGuide wire Delay Installation Guide wire delay Home Symbols Automower Operator’s manual Symptom cause and action Transport Automower from 2005W48