Husqvarna Automower manual Docked correctly in the charging

Page 76

9. Trouble shooting

Fault message

Cause

Action

 

 

 

 

 

 

Outside working area

If this occurs in isolated areas it may

Try moving the boundary wire.

 

be due to interference from metallic

 

 

objects (perimeter fence,

 

 

reinforcement bar) or buried cables in

 

 

the vicinity.

 

 

 

 

 

The working area slopes too much.

Check that the boundary wire has

 

 

been routed correctly.

 

 

 

 

The boundary wire has been routed

Check that the boundary wire has

 

the wrong way around an “island”.

been routed in accordance with the

 

 

installation instructions.

 

 

 

 

The boundary wire is too close to the

Check that the boundary wire has

 

edge of the working area.

been routed correctly.

 

 

 

Low battery voltage

Automower cannot find the charging

Change the search settings

 

station.

according to the Follow loop in (3-2-2)

 

 

on page 55.

 

 

 

 

 

Change the position of the charging

 

 

station.

 

 

 

 

The battery is spent.

Expected life is 1 - 3 years. Contact

 

 

your dealer to replace the battery.

 

 

 

Wrong PIN code

Wrong PIN code has been entered.

Enter the correct PIN code.

 

Three attempts are permitted, the

 

 

keypad is then blocked for five

 

 

minutes.

 

 

 

 

No drive

Automower has got caught in

Free the mower and rectify the

 

something.

reason for the lack of drive. If it is due

 

 

to wet grass, wait until the lawn has

 

 

dried before using the mower.

 

 

 

No contact in charging

The Automower makes poor contact

Check that the Automower has

station

with the contact strips in the charging

docked correctly in the charging

 

station.

station.

 

 

 

Charging station

The contact between the charging

Place the Automower in the charging

blocked

strips and contact strips may be poor

station and check that the charging

 

and the Automower has made a

strips and contact strips make good

 

number of charging attempts.

contact.

 

 

 

 

An object is obstructing the

Remove the object.

 

Automower.

 

 

 

 

Stuck in charging

An object is preventing the

Remove the object.

station

Automower from reversing out of the

 

 

charging station.

 

 

 

 

Upside down

The Automower leans too much or

Turn the mower the right way up.

 

has turned over.

 

 

 

 

Needs manual

The Automower is set in MAN

This behavior is normal; no action

charging

operating mode.

required.

 

 

 

76 Automower from

Image 76
Contents Operator’s manual Page Table of contents Table of contents Introduction and safety IntroductionSymbols on Automower Symbols in the Operator’s Manual Xxxxxx xxxxx xxxx xxxx xxxxxSafety instructions UseMaintenance TransportPresentation Automower, what’s what? Numbers in the picture correspond toCapacity Function of AutomowerMowing technique Working method 3012-388 3012-700 3012-400 Movement pattern Search methodSearch method 1 Irregular Search method 3 Follow guide wire Search method 2 Follow loopMore than one Automower in a garden One Automower in several gardensInstallation Carry out the installation in the following stepsPreparations Installation of the charging stationIdeal position of the charging station Low voltage cable must not be extended Transformer is for indoor use onlyInstallation and connecting the charging station Do not tread or walk on the charging station plate Installation of the boundary wire Charging the batteryBest position for the boundary wire Boundaries for the working area 3012-716 Boundaries within the working area Secondary areasPassages when mowing Passages when searching for the charging stationSlopes Laying out the boundary wire Laying the boundary wire in towards the charging station Connecting the boundary wire Joining the boundary wire3012-508 Checking the installation Need of a guide wire Installation of the guide wireLinking the Automower to the charging station Boundary wire runs along a steep slope steeper than 35 % Placement and connection of the guide wire If you shall install the guide wire through a passage 3012-675 Charging a discharged battery UseStarting the Automower Using the timerStopping the Automower Switching off the Automower RestartRestart within 20 seconds Restart after more than 20 secondsAdjusting the cutting height Cutting height can be varied from MIN 0.8 to MAXControl panel Shortcuts Programs SelectMain switch NumbersMenu functions Main menuBrowse between menus Number seriesAutomower main menu AutomowerCommands TimerDay timer Timer overrideWeekend timer Garden Week timerMon Tue Wed Thu Fri Sat Sun Run all Exit angles Proportion first Follow loopFollow loop out Distance DirectionProportion Follow loop Corridor width Test When Test in 3-2-4 is used, the house iconTest OUT Garden shape OpenNormal ComplexAdvanced Drive past wireCheck loop Settings SecurityPIN code Time lockStop protection Settings lock SoundsOperation KeypadLanguage Sound SignificanceTime and date Proposals for installation and settings Garden example proposed installation and settingsGarden shape Open Corridor width Guide wire Garden shape Normal Garden shape Complex 3012-732 Maintenance Battery ServiceWinter storage AutomowerAfter winter storage CleaningUnderframe and blade disc Replacing the blades ChassisWheels Body3012-260 Trouble shooting Fault messagesDocked correctly in the charging Symptom Cause Action Uneven mowing ResultsAutomower runs at Wrong timeEnvironmental Information Technical dataData Automower from Husqvarna Environmental information Environmental information Index AutoGuide wire Delay Installation Guide wire delay Home Symbols Automower Operator’s manual Symptom cause and action Transport Automower from 2005W48