Husqvarna Automower manual Commands, Timer

Page 49

6. Menu functions

6.3 Commands (1)

This option in the main menu allows you to access the following functions on the Automower.

•Charge then AUTO (1-1)

in order for the Automower to drive immediately to the charging station, charge the battery and then return to the automatic operating mode. Select the function and press YES when the cursor is on Yes.

•Show latest faults (1-2)

to show the list of saved fault messages. Browse with the arrow buttons. The list can contain up to 20 fault messages and each message is shown with the date and time.

•Make factory settings (1-3)

to restore all settings to their original values. Everything except the language, PIN code and the settings under the buttons A, B and are reset. Select the function, enter your PIN code and press YES when the cursor is on Yes.

6.4 Timer (2)

The lawn should not be cut too often to obtain the best mowing result. Consequently, it is important to limit the operating time using the timer function if the working area is less than 0.5 acre. When Automower is allowed to mow too much, the lawn may appear flattened. Besides, the mower is subjected to unnecessary wear.

The timer function is also an ideal means to control during which periods the Automower should not mow, for example, when the children are playing in the garden.

When you set the timer, assume that Automower mows about 800 ft2 per hour.

•Timer override (2-1)

to temporarily disconnect the timer function.

•Day timer (2-2)

to set the start and stop times.

•Weekend timer (2-3)

to set other start and stop times for the days Friday - Sunday.

•Week timer (2-4)

to select which days of the week the Automower should mow.

Commands

Timer

Garden

Settings

1

Commands

Timer

Garden

Settings

2

Charge then AUTO

Show latest faults

Make factory sett. 1-

Timer override

Day timer

Weekend timer

Week timer

2-

Automower from

™ 49

Image 49

Contents Operator’s manual Page Table of contents Table of contents Introduction Introduction and safetySymbols on Automower Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualUse Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Capacity Function of AutomowerMowing technique Working method 3012-388 3012-700 3012-400 Movement pattern Search methodSearch method 1 Irregular Search method 2 Follow loop Search method 3 Follow guide wireOne Automower in several gardens More than one Automower in a gardenCarry out the installation in the following steps InstallationPreparations Installation of the charging stationIdeal position of the charging station Transformer is for indoor use only Low voltage cable must not be extendedInstallation and connecting the charging station Do not tread or walk on the charging station plate Installation of the boundary wire Charging the batteryBest position for the boundary wire Boundaries for the working area 3012-716 Secondary areas Boundaries within the working areaPassages when searching for the charging station Passages when mowingSlopes Laying out the boundary wire Laying the boundary wire in towards the charging station Joining the boundary wire Connecting the boundary wire3012-508 Checking the installation Need of a guide wire Installation of the guide wireLinking the Automower to the charging station Boundary wire runs along a steep slope steeper than 35 % Placement and connection of the guide wire If you shall install the guide wire through a passage 3012-675 Use Charging a discharged batteryStarting the Automower Using the timerStopping the Automower Restart Switching off the AutomowerRestart within 20 seconds Restart after more than 20 secondsCutting height can be varied from MIN 0.8 to MAX Adjusting the cutting heightControl panel Shortcuts Select ProgramsNumbers Main switchMain menu Menu functionsBrowse between menus Number seriesAutomower Automower main menuTimer CommandsDay timer Timer overrideWeekend timer Garden Week timerMon Tue Wed Thu Fri Sat Sun Run all Exit angles Proportion first Follow loopFollow loop out Distance DirectionProportion Follow loop Corridor width Test When Test in 3-2-4 is used, the house iconTest OUT Open Garden shapeNormal ComplexAdvanced Drive past wireCheck loop Security SettingsPIN code Time lockStop protection Sounds Settings lockOperation KeypadSound Significance LanguageTime and date Proposals for installation and settings Garden example proposed installation and settingsGarden shape Open Corridor width Guide wire Garden shape Normal Garden shape Complex 3012-732 Maintenance Service BatteryWinter storage AutomowerAfter winter storage CleaningUnderframe and blade disc Chassis Replacing the bladesWheels Body3012-260 Fault messages Trouble shootingDocked correctly in the charging Results Symptom Cause Action Uneven mowingAutomower runs at Wrong timeEnvironmental Information Technical dataData Automower from Husqvarna Environmental information Environmental information Auto IndexGuide wire Delay Installation Guide wire delay Home Symbols Automower Operator’s manual Symptom cause and action Transport Automower from 2005W48