Husqvarna Automower manual 3012-260

Page 74

8. Maintenance

To replace the blades:

1.Set the main switch to the OFF position.

2. Wear protective gloves.

3012-288

3012-272

3.Turn the Automower upside down.

4.Rotate the skid plate so that its hole aligns with the screw for the blade.

5.Unscrew the blade. Use a straight slot or

cross-tip screwdriver.

3012-260

6.Pry apart the skid plate and blade disc a little and remove the blade and screw.

7.Screw tight the new blade.

74 Automower from ™

Image 74

Contents Operator’s manual Page Table of contents Table of contents Introduction and safety IntroductionSymbols on Automower Symbols in the Operator’s Manual Xxxxxx xxxxx xxxx xxxx xxxxxSafety instructions UseMaintenance TransportPresentation Automower, what’s what? Numbers in the picture correspond toMowing technique Function of AutomowerCapacity Working method 3012-388 3012-700 3012-400 Search method 1 Irregular Search methodMovement pattern Search method 3 Follow guide wire Search method 2 Follow loopMore than one Automower in a garden One Automower in several gardensInstallation Carry out the installation in the following stepsIdeal position of the charging station Installation of the charging stationPreparations Low voltage cable must not be extended Transformer is for indoor use onlyInstallation and connecting the charging station Do not tread or walk on the charging station plate Best position for the boundary wire Charging the batteryInstallation of the boundary wire Boundaries for the working area 3012-716 Boundaries within the working area Secondary areasPassages when mowing Passages when searching for the charging stationSlopes Laying out the boundary wire Laying the boundary wire in towards the charging station Connecting the boundary wire Joining the boundary wire3012-508 Checking the installation Linking the Automower to the charging station Installation of the guide wireNeed of a guide wire Boundary wire runs along a steep slope steeper than 35 % Placement and connection of the guide wire If you shall install the guide wire through a passage 3012-675 Charging a discharged battery UseStopping the Automower Using the timerStarting the Automower Restart within 20 seconds Switching off the AutomowerRestart Restart after more than 20 secondsAdjusting the cutting height Cutting height can be varied from MIN 0.8 to MAXControl panel Shortcuts Programs SelectMain switch NumbersBrowse between menus Menu functionsMain menu Number seriesAutomower main menu AutomowerCommands TimerWeekend timer Timer overrideDay timer Mon Tue Wed Thu Fri Sat Sun Run all Week timerGarden Exit angles Follow loop out Follow loopProportion first Proportion DirectionDistance Follow loop Corridor width Test OUT When Test in 3-2-4 is used, the house iconTest Normal Garden shapeOpen ComplexCheck loop Drive past wireAdvanced PIN code SettingsSecurity Time lockStop protection Operation Settings lockSounds KeypadLanguage Sound SignificanceTime and date Garden shape Open Garden example proposed installation and settingsProposals for installation and settings Corridor width Guide wire Garden shape Normal Garden shape Complex 3012-732 Maintenance Winter storage BatteryService AutomowerUnderframe and blade disc CleaningAfter winter storage Wheels Replacing the bladesChassis Body3012-260 Trouble shooting Fault messagesDocked correctly in the charging Automower runs at Symptom Cause Action Uneven mowingResults Wrong timeData Automower from Husqvarna Technical dataEnvironmental Information Environmental information Environmental information Index AutoGuide wire Delay Installation Guide wire delay Home Symbols Automower Operator’s manual Symptom cause and action Transport Automower from 2005W48