Husqvarna 966976701 manual Assembly of the saw attachment

Page 17

ASSEMBLY

of 4 Nm. After the machine has been in use for around 20 hours, re-tighten the screws to 4 Nm.

Assembly of the saw attachment

(327P5)

Assembly

•Loosen the coupling by turning the knob.

•Align the tab of the attachment (A) with the arrow on the coupling (B).

•Push the attachment into the coupling until the attachment snaps into place.

•Before using the unit, tighten the knob securely.

Dismantling

•Loosen the coupling by turning the knob (at least 3 times).

•Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling.

English – 17

Image 17

Contents 327P4 327P5X-series Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentMufﬂer Stop switchVibration damping system Only use cutting equipment recommended by us Quick release Balance Flex harnessCutting equipment Chain Sharpening your chain and adjusting raker clearanceSpeciﬁcation of bar and saw chain General Safety Precautions Tensioning the chain Lubricating cutting equipment Adjusting chain lubricationFilling with chain oil Checking chain lubricationWhat to do if lubrication does not work Checking wear on cutting equipment ChainChain drive sprocket May increase the risk of accidentsAdjusting the harness AssemblyFitting the cutting head Fitting the bar and chainFilling with oil AssemblyAssembling and dismantling the two-piece shaft Fitting the impact guardAssembly of the saw attachment Fuel Fuel safetyFuel Handling Mixing FuellingCheck before starting Starting and StoppingStarting and stopping StartingStopping Safety instructions while working Safety instructions regarding the surroundingsWorking Techniques General working instructionsBasic working techniques Safety instructions after completing workWithout having the cutting attachment in full view Carburettor MaintenanceCorrectly adjusted carburettor Fine adjustment of the idle speed TLow speed jet L High speed jet HCooling system MufﬂerSpark plug Is damaged it should be replacedTwo-piece shaft Cleaning the air ﬁlterAir ﬁlter Oiling the air ﬁlterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataBar and chain combinations Approved accessories Art No Use withEC-declaration of conformity Applies to Europe only Page Page Page Page 1150991-26