Husqvarna 966976701 manual Stopping

Page 21

STARTING AND STOPPING

Repeat pulling the cord until the engine starts. When the engine starts. return choke control to run position and apply full throttle; the throttle will automatically disengage from the start setting.

CAUTION! Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine.

CAUTION! Do not put any part of your body in marked area. Contact can result in burns to the skin, or electrical shock if the spark plug cap has been damaged. Always use gloves. Do not use a machine with damaged spark plug cap.

Stopping

Stop the engine by switching off the ignition.

CAUTION! The stop switch automatically returns to the start position. In order to prevent unintentional starting, the spark plug cap must be removed from the spark plug when assembling, checking and/or performing maintenance.

English 21

Image 21
Contents 327P4 327P5X-series Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentStop switch Vibration damping systemMuffler Quick release Balance Flex harness Cutting equipmentOnly use cutting equipment recommended by us Sharpening your chain and adjusting raker clearance Specification of bar and saw chainChain General Safety Precautions Tensioning the chain Lubricating cutting equipment Adjusting chain lubricationFilling with chain oil Checking chain lubricationWhat to do if lubrication does not work Checking wear on cutting equipment ChainChain drive sprocket May increase the risk of accidentsAdjusting the harness AssemblyFitting the cutting head Fitting the bar and chainFilling with oil AssemblyAssembling and dismantling the two-piece shaft Fitting the impact guardAssembly of the saw attachment Fuel safety Fuel HandlingFuel Mixing FuellingCheck before starting Starting and StoppingStarting and stopping StartingStopping Safety instructions while working Safety instructions regarding the surroundingsWorking Techniques General working instructionsBasic working techniques Safety instructions after completing workWithout having the cutting attachment in full view Carburettor MaintenanceCorrectly adjusted carburettor Fine adjustment of the idle speed TLow speed jet L High speed jet HCooling system MufflerSpark plug Is damaged it should be replacedTwo-piece shaft Cleaning the air filterAir filter Oiling the air filterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Art No Use with EC-declaration of conformity Applies to Europe onlyBar and chain combinations Page Page Page Page 1150991-26